Digital calliper with plastic housing
Digital callipers with plastic housing
CAL-DGT-(0-300MM)
Register now and access more than 125,000 products
- Simple operation using three buttons: On/Off, switching between mm and inches and 0 button for zero setting
- Robust housing with IP54 degree of protection - protection against dust and splash water
- Ground and lapped measuring surfaces ensure precise and accurate measurements
- Locking screw at the top for locking measurements
- Flat depth gauge for precise depth measurements
- Battery included
Datasheets(X)
The calliper can be used in a variety of ways for all measurements of lengths, thicknesses, depths or diameters in mechanical engineering, metalworking, workshops, the trades sector, quality control, electronics and precision engineering
Max. length measuring range | 300 mm |
Length of jaw | 60 mm |
Last viewed
1/2 inch extension
Nitrile chemical protective glove With cotton velour finish inside
Grease gun with foot operated
Screwdriver PH striking cap with hexagon shank
Twist drill bit HSS DIN 338 type RN 118°
Rust converter
Pipe and fastening clamps assortment 116 pieces in system case
1/2 inch torque wrench With push-through square drive and fine-toothed ratchet head
Circlip pliers, shape A for shaft circlips
Wire end ferrules, insulated, assortment 525 pieces in system case 4.4.1